5 6
PARTS AND DIAGRAM LIST
Item No. Quantity Part Name
A 1 Adjustable wand
B 1 Spray gun
C 1 High-pressure hose
*D 1 Water filter
E 1 Handle
F 1 Detergent bottle assembly
G 1 Hose bracket
H 1 Gun holder
I 1 Power cord bracket
J 3 Short screws
L 1 Needle (for nozzle cleaning)
K 2 Long screws
* Water filter come pre-attached on the water inlet, located on the front of the pressure washer.
E
D
C
B
A
G
H
I
F
Surface Preparation
Before starting any cleaning task, it is important to inspect the area for objects that could
Tools Required
• Philips Screwdriver
create a hazard. Remove any objects from the work area that could be tripped over, such as
toys or outdoor furniture. Ensure that all doors and windows are closed tightly.
Water Supply (Cold Water Only)
Only draw water through the unit. For use with cold water supply only. Water hose must be
at least a 1/2” (13 mm) in diameter. Flow rate of water supply must not fall below 2 GPM
(gallons per minute) [9.1 lpm (litres per minute)]. Flow rate can be determined by running
the
temperature must not exceed 104°F (40°C).
water for one minute into an empty 5-gallon (19 L) container The water supply .
CAUTION
• Never use the pressure washer to draw in water contaminated with solvents (e.g.
paint thinners, gasoline, oil, etc.).
• Dirt in the water inlet will damage the unit.To avoid this risk, we recommend checking
the water (located inside the water inlet.To clean it out see Maintenance section).
• Always prevent debris from being drawn into the unit by using a clean water source
and an additional accessory water if required.
•To prolong the life of the unit, rest the unit for 5 minutes after every 30 minutes of use.
ASSEMBLY AND OPERATING INSTRUCTIONS
1
Assemble handle onto pressure washer
and attach hose bracket to handle. Tighten
all the screws.
Connect detergent suction tube to the
bottle and attach to the handle.
2
K
L
J
1(J)
3(G)
2(K)
Comments to this Manuals