Clean Force CF1400 Operations Instructions download pdf (Page 6)

9 10

ASSEMBLY AND OPERATING INSTRUCTIONS

Adjustable Spray Nozzle

The adjustable spray nozzle can be adjusted from fan to jet. The spray is adjusted from jet

to fan spray by turning the nozzle.

Working with detergent ensures a quick soaking of the dirt, and allows the high-pressure

water to penetrate and remove the dirt more effectively. Always spray detergent on a dry

its cleaning ability.

To apply detergents you must be operating at low-pressure. This provides a gentle applica-

tion of detergent, with the pressure equivalent to a lowest garden hose. The high-pressure

setting is used for cleaning; you cannot apply detergents when working at high-pressure.

Always test detergent in an inconspicuous area before use.

CAUTION

Only use cleaning detergents recommended for pressure washers.

USING THE ACCESSORIES

WORKING WITH DETERGENTS

Engage gun safety lock.

Set the adjustable wand to the low-

pressure setting by pulling the nozzle out.

The wand must be set in the low-pressure

position to apply detergent.

CAUTION

Jet spray adjustment is very aggressive. Do not adjust while spraying.

1 2

ASSEMBLY AND OPERATING INSTRUCTIONS

Turn on the pressure washer. Pull trigger to operate unit. The liquid detergent will automati-

cally mix with water, and be discharged through the nozzle at low pressure. Apply detergent

to a DRY work surface, from bottom to top.

with detergent. Push containers back into storage position.

Allow detergent to remain on the surface for a short time before rinsing. Do not allow

detergent to dry on surface.

Rinse with clean water under high pressure. On a vertical surface, rinse from the

bottom up, then rinse from the top down to avoid streaking. Hold nozzle 6-8” (15-20

cm) from the work surface, at a 45° angle.

with clean water. Siphon water at low pressure for one minute, so that all detergent is

CAUTION

Damage may occur to painted surface if chemical is allowed to dry on surface. Wash

and rinse a small section at a time. Avoid working on hot surfaces or in direct sunlight.

1 2 3 4 5 6 7 8 9 10

No comments

Clean Force CF1400 Operations Instructions Page 6